To Next PageTo Next Page
Need help?Do you have a question about the ORKEL MP 2000 and is the answer not in the manual?
General| Type | Round Baler |
|---|---|
| Model | MP 2000 |
| Brand | ORKEL |
| Hydraulic System Pressure | 180 bar |
| Bale Size - Diameter | 1.2 m |
| Bale Size - Width | 1.2 meters |
| Capacity | Up to 60 bales/hour |
Identifies the machine, its serial number, and declaration of conformity.
Covers warranty liabilities, limitations, procedures, and related forms.
Defines danger, warning, and caution terminology and their implications.
Provides safety precautions for maintenance and control after repairs.
Details safe work routines, operator and bystander safety, and risks.
Explains safe transport preparation, lifting, and strapping procedures.
Introduces the control box, its functions, menus, and buttons.
Explains access to advanced parameters for trained personnel only.
Guides on setting and changing operator parameters and recommended values.
Covers changing display brightness, contrast, and background options.
Details how to perform a sensor test and interpret its results.
Explains how to access and interpret fault and error messages for troubleshooting.
Lists error and fault messages with corresponding sensor IDs and states.
Describes the main sections and operational modes of the compactor.
Explains tractor connection, PTO speed, electrical, and hydraulic systems.
Details binding in chamber, adjusting net-brake, wrapper table, and knives.
Explains the automatic operation sequence and working parameters.
Explains the machine's automatic operation and operator's role.
Details safety and preparation steps for driving the machine on the road.
Provides a step-by-step guide for preparing the machine for road transport.
Gives instructions for rigging up the compactor after it has been transported.
Details connecting the tractor, PTO speed, electrical, and hydraulic systems.
Lists controls and functions to check before starting up the machine.
Explains binding the bale in chamber with film or net using the HiT unit.
Details the process of binding the bale in the chamber with film or net.
Details speed regulation, height setting, and alignment of wrapper knives.
Provides instructions for loading and installing a new plastic film roller.
Explains the sequence of operations when the start button is pressed.
Covers hydraulic valve operation, adjustments, and settings.
Details maintenance for electric, hydraulic systems, wheels, chains, and wrapper.
Covers lubrication system, refill procedures, and recommended types of grease/oil.
Details electrical system checks, fuses, and cabinet inspections.
Explains the automatic lubrication system for sleeve bearings and chains.
Lists daily checks to perform before starting the machine.
Lists daily checks to perform while the machine is operating.
Outlines operational voltage, current draw, RPM, and capacity.
