ORKEL MP 2000 - 4.5.5- Loading;installing a new plastic film roller

46
- 

1. Grab the bow on the pre-stretch unit, and pull to the right.
2. Li the locking lever and push the bracket upwards, the lock the lever temporary.
3. Replace the empty roller with a new one.
4. Centre the roller on the holders and lover the bracket to secure it. Lock the lever.
5. The plasc lm must be thread as shown in gure 2, then grab the bow and lay the pre -stretch unit
on to the new lm roller.
6. Bind the two plasc lm ends together, (from each side) and connue wrapping.
Figure 2 Plasc lm in pre –stretcher
Plasc lm holder and pre-stretcher
Pre-stretch bow
Locking lever