47
The hydraulic motor for chamber belt rotaon is starng, the elevator and belt under motor is starng. Ma-
terial is being fed into the chamber, controlled by a sensor in elevator.
When the pre-set value of chamber full level is reached, the elevator speed is reduced to reduce the feeding
amount into chamber. The bale is now being pressed unl a pre-set value chamber pressure is achieved.
The net knife is opening and the net motor is starng feeding net/lm into the chamber. A pre-set numbers
of layers of lm/net is added to the bale, and the lm/net is then being cut by the knife.
The chamber tailgate opens and the bale is being transported on to the wrapper table. A wrapper sensor is
acvated and the wrapper table moves to horizontal posion, another sensor is then being acvated and
close the tailgate. A new bale is then being processed.
At the same me the wrapper cycle start. Wrapper arms speed is reduced the rst turn, unl the knife arms
release the lm. The wrapper arm speed is then increased to “fast” unl a pre set number of layers is added
to the bale.
The number of layers being added to the bale on wrapper table, are depending on which material is being
pressed, if the bale is to be stored or transported. Read the user manual from lm roller supplier.
To Next Page
Loading...