53
-
By adjusng valve nr. 55, the speed could be changed. The speed is to be set as fast as possible, without
slamming the tailgate.
By adjusng valve nr. 56, the belt speed on the feeder table is set.
-
Belt under speed is set by adjusng the valve nr. 57 (fast) and nr. 58 (slow).
The conveyor belt speed, in the elevator is adjusted by turning on valve nr. 59 (fast) and nr. 60 (slow)
-
There must be some pre tension added to the lm before it’s added on to the bale. Adjust the brake by turn-
ing valve nr. 61. By turning the knob clock wise, the tension is increased.
Adjust the feeder speed by turning valve nr. 62. the speed is reduced when turning the valve clock wise.
By closing valve nr. 63, the net brake can be disengaged. This operaon is performed when loading a new
lm og net roller in HiT unit.
-
The machine is equipped with four main valves. Valve number: 64, 65, 66 and 70.
To Next Page
Loading...