ORKEL MP 2000 - 4.4 CONNECTING THE MACHINE.; 4.4.6- Function controls, before starting up

43
 
- 
The tractor must be placed on the le side of the machine. See secon 4.3.2
- 
The machine require a PTO speed of på 850 RPM. Ensure the tractors RPM correspond to this.

- 
The machine is designed to be connected to a 12Volt DC system with negave earth. The electronic is over/
under voltage protected. The voltage must be stabile between 10,6V and 16V. Make sure the tractors elec-
trical system is in good order.
Connect the power cable directly to the baery on tractor. The cable is secured by a 40A fuse (on cable).
The signal cable from control box must be connected to corresponding socket under the switchboard casing.
The control box is equipped with magnets, allowing it to be placed directly on the machine. Preferably it can
be placed on the right side, near the wrapper zone.
The control box should be disconnected and stored in dry condions. Always keep connectors clean and dry.
- 

Hydraulic power supplied from tractor system operate the four hydraulic jack-stands, drag bar and feeder
table liing cylinders. All other hydraulic power is serviced by a integrated hydraulic pump, located on the
machines le side.
- 
A temperature indicator is aached to the oil reservoir. Read the oil temperature, if the oil temperature is
too cold, do this: Run tractor on idle speed, with 300 RPM on PTO axle, approximately 10
to 25 minutes unl the temperature has reached start temperature. A scker on the oil
reservoir, is stang which oil type the machine is equipped with.
(minimum start temp. ÷ 15°C) Warm up me 10 min. + one minute per minus
degree.
(minimum start temp. ÷ 3°C) Warm up me 10 min + one minute per minus
degree.
Increase PTO speed to 850 RPM when the oil has reached operang temperature.
- 
The drag-bar must be in operaonal posion (in).
- Wrapper table, up and down funcon. The table must be set in horizontal
posion aer being checked.
- Sensors on wrapper table. Up - horizontal and down . (Sensor test in control box.)
- Wrapper arm, low speed. Press ”slow”. Set speed to 10 RPM (basic seng ), by adjusng valve nr. 69 .
- Wrapper arm, fast speed. Press ”fast”. Set speed to 25 RPM (basic seng ), by adjusng valve nr. 51
Adjusng the wrapper is described in chapter 4.9.2
Temperature indicator