– 52 –
At the end of a measurement, this monitor automatically stores each
result with date and time. Each unit stores 120 sets measurements
for 2 users(User A and B).
With the unit off, press the Memory button. The display first shows
„A”, then shows an average of all measurements stored in the unit.
Please note: Measurements for each user are averaged and stored
separately. Be certain that you are viewing the measurements for the
correct user. Pressing the Memory button again displays the previous
value. To view a particular stored memory, press and hold the Memo-
ry button to scroll to that stored reading.
If it is necessary to interrupt a blood pressure measurement for any
reason (e.g the patient feels unwell), the Start/Stop button can be
pressed at any time. The device then immediately lowers the cuff
pressure automatically.
Batteries discharged– replacements required
When the batteries are discharged, the battery symbol will flash as
soon as the instrument is switched on. You cannot take any further
measurements and must replace the batteries.
The battery compartment is located on the back side of the unit
a) Remove cover from the bottom plate, as illustrated below pictu-
re-08
b) Insert the batteries (4 x size AAA ). Always use AAA long life bat-
teries or alkaline 1.5v batteries.
c) The memory retains all values although date and time must be
reset - the year number therefore flashes automatically after the
batteries are replaced.
d) To set date and time, follow the procedure described in Section
4.2.
To Next Page
Loading...