Orphek Atlantik V4 User Manual

Resetting your Atlantik V4 to Factory Default
Under unusual circumstances you may have to reset your Atlantik V4 to factory
default.
This usually happens when you cannot connect to your light.
Resetting your light is a very simple process.
1. Remove power from your gateway.
2. Rapidly plug the power supply in and out of the power receptacle four times. Your
light should flash twice and remain on at 80% intensity.

Orphek Atlantik V4 Specifications

General

Driver	Mean Well driver
Material	Aluminum housing
Frequency	50/60Hz
Light Spectrum	Full spectrum
Control Type	Wi-Fi / App Control
LEDs	High power LEDs
Cooling	Passive cooling
Color Channels	8 channels
Voltage	100-240V
Compatibility	Android, iOS

Summary

Resetting your Atlantik V4 to Factory Default

Remove Power from Gateway

Disconnect power supply from the gateway before starting the reset procedure.

Perform Power Cycling Reset

Rapidly plug and unplug the power supply four times to initiate the reset.

Apply Power and Allow Completion

Reapply power to the gateway and wait for the reset process to finish.

Configure Gateway ID in App

Enter the device's gateway ID into the Orphek app to complete setup.

Access Video Guide

A link to a video tutorial is provided for visual assistance.