40
.. CHARGING
Carefully lift the electronics cover (E) to
access the USB-C port (D).
Use the supplied USB-C cable (R) to
charge the device via a USB power source
(e.g., a laptop) or with a USB charger
(see point 1).
The LED lights (F) indicate the charging
status (see point 4.3).
Remove the USB-C cable as soon as
charging is complete and carefully close
the electronics cover again to prevent
moisture or dirt from penetrating.
PLEASE NOTE:
You must charge the battery before
first use.
To ensure full performance, we recom-
mend that the system is charged for more
than 24hrs before first use and after
prolonged storage.
Carefully lift the electronics cover (E).
To turn the system on, press the ON/OFF
button (C) for 2+ seconds. All three LED
lights (F) will light up and there will be a
rising series of beeps when powering on.
Each time the LiTRIC System is switched
on it will perform an automatic self-test.
The LEDs show that the device is being
charged internally (see point 4.3).
As soon as the system is ready for
deployment, it will automatically run a
brief motor test and shortly afterward the
LED lights will indicate the charge status
(see point 4.3). The LiTRIC system is now
ready to deploy.
4. OPERATION
ATTENTION
The trigger handle should be locked (see
point 4.4.1) while charging. The airbag may
deploy if the trigger handle is pulled when
the LED lights) are on, even during
charging.
Do not leave the USB-C cable plugged in
while the LiTRIC Avalanche Airbag is in use
in the backcountry.
.. ON/OFF FUNCTION
To Next Page
Loading...
