Ortur Laser Master 2 PRO S2 User Manual

1
Dongguan Ortur Intelligent Technologies Co., Ltd.
https://ortur.tech/olm2pros2
No.1 Building, Ruijin Science and Technology Industrial Park, Changping, Dongguan 523558, Guandong Province, China
Firmware Update Instructions v1.87
15 December 2021
Ortur Laser Master 2 PRO S2

Ortur Laser Master 2 PRO S2 Specifications

General

Engraving Area	400 x 400 mm
Laser Power	20W
Control Software	LaserGRBL, LightBurn
Connectivity	USB
Laser Type	Diode Laser
Warranty	1 Year
Laser Output Power	5.5W
Safety Features	Active Position Protection, Laser Beam Safety Guard, Exposure Duration Detection and Limitation
Supported Materials	Leather, Paper, Wood, Acrylic
Engraving Speed	10, 000 mm/min
Focus Mode	Manual
Cooling System	Air Cooling
Frame Material	Aluminum
Power Supply	24V
Operating Temperature	5°C - 35°C
Storage Temperature	-10-60°C

Summary

Ortur Laser Master 2 PRO S2 Firmware Overview

General Recommendations for Firmware Updates

Guidance on when to upgrade or reinstall the firmware for optimal performance.

Requirements for Safe Firmware Upgrade

Details necessary software, hardware, and precautions for a successful firmware update.

Basic Troubleshooting for Ortur Laser Master 2 PRO S2 Firmware

Troubleshooting: Firmware Write Fail

Addresses issues where the firmware file fails to copy to the motherboard.

Troubleshooting: Wrong Firmware File Errors

Explains errors due to incorrect firmware file format or type.

Windows Firmware Update Procedure

Windows: Retrieve Firmware Files

Instructions for downloading the correct firmware version from the Ortur website.

Windows: Enable Firmware Mode

Guide to put the Ortur Laser Master 2 PRO S2 into DFU mode for updating via USB.

Windows: Confirm Firmware Write Success

Steps to verify successful firmware installation and initial setup on Windows.

Firmware Verification using LaserGRBL

LaserGRBL: Connect and Check Firmware Version

How to start LaserGRBL, connect, and identify the firmware version.

LaserGRBL: Resetting Device Defaults

Sending the $RST=* command to restore factory defaults via LaserGRBL.

Firmware Verification using LightBurn

LightBurn: Connect and Check Firmware Version

How to start LightBurn, connect, and identify the firmware version.

LightBurn: Resetting Device Defaults

Sending the $RST=* command to restore factory defaults via LightBurn.

MacOs Firmware Update Procedure

MacOs: Retrieve Firmware Files

Instructions for downloading the correct firmware version from the Ortur website.

MacOs: Enable Firmware Mode

Guide to put the Ortur Laser Master 2 PRO S2 into DFU mode for updating via USB.

MacOs: Confirm Firmware Write Success

Steps to verify successful firmware installation and initial setup on MacOs.

Linux Firmware Update Procedure

Linux: Retrieve Firmware Files

Instructions for downloading the correct firmware version from the Ortur website.

Linux: Enable Firmware Mode

Guide to put the Ortur Laser Master 2 PRO S2 into DFU mode for updating via USB.

Linux: Confirm Firmware Write Success

Steps to verify successful firmware installation and initial setup on Linux.