- 33 -
EN
1 . Adjust the child car seat to the maximum reclining position and turn it so that it points to the
R1 - 40–75 cm seating position in rear-facing orientation. If your child's height exceeds 75 cm,
please change to the seat position R2 - 76–105 cm.
2 . Press the two side Isofi x connector buttons to extend the length of the Isofi x connectors.
3 . Fold out the support leg underneath the child car seat.
4 . Guide the Isofi x connectors to the Isofi x anchor points on the car seat and snap them into
place.
5 . Push the child car seat in until it rests securely against the backrest of the vehicle seat. Ensure
that both Isofi x indicators are showing green.
6 . Adjust the height of the support leg and ensure that this is fully in contact with the footwell
of your vehicle.
7 . Ensure that the indicator on the support leg is switched to green.
8 . When placing your child in the child car seat, turn the car seat towards the car door for con-
venience.
9 . Unfasten the belt buckle on the child car seat and place the belts over the outside of the seat.
10 . Put your child in the child car seat.
11 . Adjust the height of the headrest as described above.
12 . Fasten the belt buckle again until you hear a click.
13 . Pull the front adjustment strap to tighten the belts.
14 . Ensure that the straps are not twisted.
15 . Turn the seat into the rear-facing position. Check that the child car seat is locked in this
position.
To Next Page
