osann JUNIOR - Installation; Maintenance Advice; Warning: Universal Classification

Installaon
Must be used for fastening a cered (ECE R16 or
equivalent standard) 3-point harness. Put the seat
on the vehicle seat and put the child into it. Fasten
the child with the 3-point seat belt buckle unl it
„clicks“. Refer to the adjacent drawing. The diagonal
belt should go over the shoulder of the child, as well
as over the armrest. Make sure that the belt ts
ghtly and is not twisted.
Storage of the instrucon manual
Store this instrucon manual, depending on the model of your vehicle, either in the pouch provi-
ded, or by slipping it into between the shell and the cover of the seat.
Maintenance advice
All the material parts can be removed. Slight stains can be removed using a damp sponge soaked in
soapy water or it can be washed by hand at 30° in soapy water. Do not use bleach, do not iron, do
not machine wash, and do not tumble dry.
WARNING
• This car seat is a “Universal” child restraint system. It has been approved in accordance with
regulaon N°44/04, and is suitable for general use in vehicles and is compable with the majority
(some excepons) of vehicle seats.
• It is more likely that the seat is perfectly compable if the vehicle manufacturer states that its
vehicles are suitable for taking “Universal” child restraint systems.
• This restraint system is classied as “Universal” in accordance with the strictest approval criteria,
whereas earlier models do not correspond to these new provisions.
• It can only be adapted to vehicles with 3-point safety belts that are either xed or have a roller
mechanism and that have been approved compliant with the UN/ECE N° 16 or other equivalent
standards.
• If in doubt, contact the manufacturer or retailer of the restraint system.
EN