Fi ng the car seat for 9-18 kg
1. Rotate out the Iso x connectors un l you hear ”Click”. Check that the Iso x connector is moving
within the angle of 15°, and cannot turn around.
2. Pull a erwards the black plas c coat of Iso x connectors un l red appears in the window.
3. Put the red plas c protectors on the correct posi on on the car, in order that the Iso x connec-
tors can get into these protectors.
4. Place the child safety seat on the vehicle‘s seat. Push the Iso x connectors towards the xed
points un l green appears in the window.
5. Open the vehicle latch connector cover, let top tether hook lock the latch anchorage points to
make sure the tether is fully ghtened. At this me, the latch connect will show the green window
as well. So the child car seat is rmly pressed against the vehicle seat backrest.
If in doubt, consult either the child restraint manufacturer or the retailer.
WARNING: The car seat belt cannot be used to any iden ed forcing point.
Adjust the headrest height
According to children‘s di erent height, the head-
rest can be adjusted up and down.
1. Put one hand on the backrest.
2. Pull the red bu on with your other hand.
3. Make the headrest up and down as you need.
Make sure that the posi on ts for your child.
EN
To Next Page
Loading...
Need help?
General
Weight and Dimensions
