OSIM uCheck Smart - Page 10

8
Preparation before use
Setting year
Press and hold the [ ] ‘Time’ button until ‘Year’ display starts
blinking.
1) Press the [ ] ‘Memory’ button to adjust.
2) To confirm selection, press the [ ] ‘Time’ button.
Setting month, day and time
Once you finished setting the year, the ‘Month-day’ display
would start blinking.
• Repeat step 1 & 2 to select month, day and time.
Note:
• The ‘Hour’ values are in 24H format.
• Press & hold the [ ] ‘Time’ button to reset the year,
month, date and time.
Setting measurement unit
The default measurement unit is mmHg.
1) To switch the measurement unit from mmHg to kPa, press
and hold the [ ] ‘ON/OFF’ button until the LCD screen
shows ‘0.0’ for kPa, then release the button.
2) To switch the measurement unit from kPa to mmHg, press
and hold the [ ] ‘ON/OFF’ button until the LCD screen
shows ‘0’ for mmHg, then release the button.