Wireless Interface 1 / Wireless Interface 2:
On the device the inner N connector is for WLAN1 interface and the outer N connector is for
WLAN2 interface.
Status – Enabled or Disabled, depending on the current configuration.
MAC Address – MAC address of the wireless interface.
WLAN Mode – Access Point (802.11a compatible) or Polling Base Station (OSBRiDGE
proprietary WLAN MAC protocol, optimized for outdoor networks).
ESSID - ESSID of the WLAN interface. All wireless devices on a common wireless network must
employ the same ESSID in order to communicate with each other.
Frequency – Current frequency the interface is configured to operate on.
Channel Width – Channel width the device is configured to operate. Available values are 20
MHz (standard width), 10 MHz (half width), 5 MHz (quarter width) and 40 MHz (802.11a Turbo
mode).
Data Rate – Configured Data Rate for specific WLAN interface.
Supported Data Rates – Wireless Data rates the device supports.
Available Data Rates are:
6, 9, 12, 18, 24, 36, 48 and 54 Mbps for regular 802.11a mode,
12, 18, 24, 36, 48, 72, 96 and 108 Mbps in 802.11a Turbo mode,
3, 4.5, 6, 9, 12, 18, 24 and 27 Mbps for 802.11a mode with 10 MHz channel width,
1.5, 2.25, 3, 4.5, 6, 9, 12 and 13.5 Mbps for 802.11a mode with 5 MHz channel width.
TX Packets – Number of data packets that have been transmited by the Access Point.
TX Errors – Number of errors in packets that have been transmited by the Access Point.
TX Bytes – Number of bytes transmited by the Access Point.
RX Packets – Number of data packets that have been received by the Access Point.
RX Errors – Number of errors in packets that have been transmited to the Access Point.
RX Bytes – Number of bytes received by the Access Point.
Fragmentation Threshold - The size at which packets are fragmented on the WLAN interface.
Cell Size (km) - Configure distance between OSBRiDGE 5G device and the most distant client
connecting to it.
To Next Page
Loading...