Need help?Do you have a question about the Osmio Duo Hydrogen and is the answer not in the manual?
Highlights key technologies like PEM and SPE, material quality, and operational capabilities of the hydrogen water bottle.
Step-by-step instructions for initial setup, including washing, charging, and filling the hydrogen water bottle.
Details on 5-min and 7-min cycles, drinking, battery status, and proper placement for ozone release.
Step-by-step guide for attaching and using the breathing cannula for inhaling hydrogen gas.
Instructions for attaching different bottles to the generator using supplied adaptors to ensure a tight seal.
Procedure for descaling electrolysis plates using vinegar, lemon juice, or citric acid.
Common issues like no bubbles, low PPM, battery problems, and their solutions.
The Osmio Duo Hydrogen Water Bottle is a portable device designed to generate hydrogen-rich water through advanced electrolysis technology. It utilizes a Proton Exchange Membrane (PEM) and Solid Polymer Electrolysis (SPE) to produce hydrogen, while also separating and expelling harmful by-products such as chlorine, ozone, and oxides. The bottle is compatible with all types of safe drinking water.
The primary function of the Osmio Duo is to enrich water with hydrogen gas. To begin the electrolysis process, the user presses the power button. A blue indicator light signifies a 5-minute cycle, generating hydrogen for that duration. Pressing the button a second time activates a green indicator light, initiating a 7-minute cycle for a higher concentration of hydrogen. A third press of the button turns the device off. After a cycle, the working indicator light turns off, indicating completion. If the indicator light flashes red, it signals a low battery that needs charging. The hydrogen water can be consumed directly from the bottle or poured into another container, with optimal consumption recommended within one hour as hydrogen dissipates over time.
The device also offers an alternative method for hydrogen intake through a breathing cannula. This feature is particularly useful when drinking water is restricted, such as during travel or before bed. The cannula kit includes a special bottle lid with a snorkel valve and a breathing tube. To use, the user fills the bottle three-quarters full with water, attaches the adapter lid with the cannula tube, and places the breathing prongs into their nostrils. The slack-bead behind the neck can be adjusted for a snug fit. The bottle is then cycled on a 7-minute cycle repeatedly to generate enough pressure to push hydrogen gas through the cannula tube and into the nose. The user can continue cycling until they no longer wish to inhale the gas. If using for longer than 7 cycles, the water should be replaced.
The Osmio Duo is versatile and can be used with other bottles. It comes with two different adaptors to match various bottle necks. To use, the user selects the appropriate adaptor, screws it tightly onto the generator (using the generator cover sideways for leverage), then screws the generator with the attached adaptor onto their chosen bottle, ensuring a tight seal to prevent leaking. The unit is then inverted to generate hydrogen into the attached bottle.
Before first use, the glass bottle and lid should be washed with warm soapy water to remove sanitization liquid. The silicone generator plug, which seals the generator for moisture retention during shipment and storage, should be removed and kept in a safe place. The clean, dry glass bottle is then twisted onto the generator and hand-tightened, with the lid screwed back on. The device requires an initial charge of 2-3 hours until fully charged, indicated by the red light stopping blinking and remaining on. After charging, the generator should be rinsed with warm water while the bottle is attached. Finally, the bottle is filled with clean drinking water, ready for the electrolysis process.
It is important not to cycle the bottle more than once when drinking the water to avoid over-concentration. The unit should always be operated on a flat surface to allow the ozone gas release valve on the bottom to open properly. When using other bottles, ensure the generator is screwed on tightly to prevent leaks.
Regular maintenance is crucial for the longevity and performance of the Osmio Duo. The generator should never be allowed to dry out; a small amount of water should always be left in the bottom to keep the electrode plates moist. When storing or traveling, the silicone generator plug should be installed. Overcharging the battery should be avoided; the charger should be removed as soon as the red light stops blinking and remains on, as overcharging can drastically deteriorate battery life.
The purity of the water used directly impacts hydrogen production, with purer water yielding more hydrogen. The unit should be cleaned twice a month as directed. Depending on the mineral oxide content in the drinking water, the electrolysis plates should be descaled once or twice a month. Using reverse osmosis filtered water can help prevent the need for frequent descaling. For descaling, a mixture of 1 part white vinegar, lemon juice, or citric acid to 3 parts water is added to the bottle, and the generator is left to soak overnight. The mixture should then be discarded, and the bottle thoroughly rinsed with warm water before next use.
After three or more cycles, some waste water may accumulate in the bottom chamber. To release this, the bottom chamber should be unscrewed and the water drained. If no water is discharged, it indicates that the machine is adequately controlling pressure, and waste O3 and chlorine are being discharged as a gas. The USB port should always be kept sealed by plugging its cover back in. The device should only be operated with clean and safe drinking water, preferably filtered, but tap water can also be used. It is not suitable for hot, carbonated, or other beverages, and room temperature water should be used. Freezing or using ice is not recommended. Direct sunlight or heat that could dry out the plates should be avoided. It is not recommended to drink water that has been cycled more than twice; if cycling more than twice without the cannula attached, the gas pressure at the lid should be released. The device should be kept away from children, pets, heat, and flames.
General| Type | Hydrogen Water Dispenser |
|---|---|
| Model | Osmio Duo Hydrogen |
| Color | White |
| Hydrogen Production | Up to 1500 ppb |
| ORP | -400 to -600 mV |
| Filter Life | 6-12 months |
| Voltage | 220-240V |
| Material | Stainless Steel |
To Next Page