To assure the correct use of the product basic safety measures should always be
followed including the precaution listed as below:
Please read all information in the instruction manual and any other literature
included in the box before using the unit.
Please contact your physician for specific information about your blood pressure.
Self-diagnosis and treatment by measure results may be dangerous. Follow the
instructions of your health care provider.
Operate the unit only as intended. Don't use for any other purpose. The unit is
intended to use in measuring blood pressure and pulse rate for adult only, not
recommended using for newborn baby at home or medical centre.
Do not use a cellular phone near the unit. It may result in operational failure.
Please avoid using in high radiant area in order to make your measuring data
correct.
Do not disassemble or attempt to repair the unit or components. Do not use the
equipment in places where there are flammable gas (such as anesthetic gas,
oxygen or hydrogen) or flammable liquid (such as alcohol) .
Do not use a mobile phone or other devices that emit electromagnetic elds near
the unit.
This may result in incorrect operation of the unit.
Indicating that too frequent measurements can cause injury to the PATIENT due to
blood flow interference;
Please do not put CUFF over a wound, as this can cause further injury;
Please pay attention to the effect of blood flow interference and resulting harmful
injury to the PATIENT caused by continuous CUFF pressure due to connection
tubing tangling;
Statement regarding the requirements of the adapter, it should meet the
following conditions, output voltage: DC 5V, Current: 1000mA, and comply with
IEC 60601-1 and IEC 60601-1-11, provide two MOPP insulation between ac input
and dc output.
Do not install the battery on the wrong polarity.
After the battery power is o, please replace four new batteries.
If over three months do not use the device, please remove the battery as it may
cause leakage, overheat, rupture and damage the blood pressure monitor
casing.
1.2 Important safety notices