POCO AG™ SERIES
6
ASSEMBLY
SUNSHADE
Included on all Poco AG™ models the built-in sunshade is easily stored and deployable
from its own zippered pocket. It offers quick and easy UV protection for the child.
1 Unzip the sunshade pocket
marked with woven label.
2 Grab the webbing loop on the
top of the sunshade and pull the
sunshade out of the pocket. Align
the hook and loop at the base of
the sunshade with the hook and
loop at the top of the pocket.
Press together to secure.
3 Securely grab the two red tabs
and pull them forward.
4 Insert the red tabs into the sleeves
at the front of the sidearms to
secure and tighten the sunshade.
Your sunshade is now installed.
TO STORE YOUR BUILT-IN SUNSHADE, FOLLOW THESE STEPS:
5 Place fingers in red webbing loops and pull red tabs out of their sleeves.
Ensure to the keep your fingers hooked into the red loops to prevent the
sunshade from springing back at the child.
6 Separate the hook and loop at the base of the sunshade. Slide the
sunshade down into the storage pocket and zip the storage pocket shut.
2 Pull down on the drool pad to release the hook and loop at the lower corners.
To reinstall drool pad follow the above steps in the reverse order.
DROOL PAD
The drool pad at the front of the cockpit is soft to the touch and comfortably padded for the child. It can be removed for
cleaning when necessary. Clean with warm water and mild detergent. Air dry in a well-ventilated area out of direct sunlight.
To remove and clean, follow these steps:
1 Unbuckle the upper drool pad buckles from the top of the backpanel.
To Next Page
Loading...
Need help?
General
