To Next PageTo Next Page
Need help?Do you have a question about the OSTBERG CK and is the answer not in the manual?
Fan accessible for user service; safety disclaimers for persons with reduced capabilities.
Fan transports clean air; continuous operation for max life time; use at stated voltage/frequency.
Can be installed outdoors or in damp areas with drainage; can be installed in any position.
Transport in original packing; be aware of sharp edges and avoid extreme temperatures.
Install according to air direction label; connect to duct or use safety grille.
Install safely, ensure no foreign objects, facilitate service/maintenance, consider weight/size.
Prevent vibration transfer; electrical work by authorized electrician; use local isolator, grounding, protection.
Speed regulation via transformer/thyristor; built-in thermal contact; capacitor replacement needed.
Speed control via potentiometer; tachometer output; EMC installation; analog input warning.
Check current tolerance, voltage tolerance, noise, and rotation direction before starting.
Disconnect power, wait for impeller stop; beware of sharp edges and fan weight.
EC motor housing can be hot (up to 85°C); 3-min wait for EC motor due to capacitors.
Secure fan when open; clean annually without high-pressure or solvents; bearings are maintenance-free.
Check power, impeller blockage, thermal contact, capacitor, and contact supplier if issues persist.
Warranty valid if used per instructions and regularly maintained; excludes third-party accessories.
Confirms product compliance with EU directives and harmonised standards for safety and EMC.
Fan accessible for user service; safety disclaimers for persons with reduced capabilities.
Fan transports clean air; continuous operation for max life time; use at stated voltage/frequency.
Can be installed outdoors or in damp areas with drainage; can be installed in any position.
Transport in original packing; be aware of sharp edges and avoid extreme temperatures.
Install according to air direction label; connect to duct or use safety grille.
Install safely, ensure no foreign objects, facilitate service/maintenance, consider weight/size.
Prevent vibration transfer; electrical work by authorized electrician; use local isolator, grounding, protection.
Speed regulation via transformer/thyristor; built-in thermal contact; capacitor replacement needed.
Speed control via potentiometer; tachometer output; EMC installation; analog input warning.
Check current tolerance, voltage tolerance, noise, and rotation direction before starting.
Disconnect power, wait for impeller stop; beware of sharp edges and fan weight.
EC motor housing can be hot (up to 85°C); 3-min wait for EC motor due to capacitors.
Secure fan when open; clean annually without high-pressure or solvents; bearings are maintenance-free.
Check power, impeller blockage, thermal contact, capacitor, and contact supplier if issues persist.
Warranty valid if used per instructions and regularly maintained; excludes third-party accessories.
Confirms product compliance with EU directives and harmonised standards for safety and EMC.
General
