For questions, contact Oster
®
brand customer service: (800) 334-0759 or visit www.Oster.com. © 2010 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved.
1
ASSEMBLE IT
2
LOAD IT
3
FILL IT
4
SHAVE IT
5
BLEND IT
6
POUR IT
TIP: Store-bought ice (thawed for 15-30
minutes) usually works best. Never put
anything but ice in the ICE SHAVER ASSEMBLY.
Fill ICE RESERVOIR to max
ICE LEVEL with ice and put
on ICE RESERVOIR LID.
Turn clockwise to loosen,
counter-clockwise to
tighten.
TIP: Never put anything but ice in the
ICE SHAVER ASSEMBLY.
Place BASE on clean, dry, flat
surface with control panel facing
you. Place ICE RESERVOIR (clear
plastic bowl) on top of ICE SHAVER
MAIN BODY. With handle on left,
place ICE SHAVER MAIN BODY on
motor BASE. To LOCK components
together, turn counter-clockwise
(use aligning arrows).
TIP:
Don’t overfill! Many blended
drinks increase in volume after blending.
Fill the BLENDER JAR
with drink mix.
Remove ICE SHAVER
ASSEMBLY and place the
BLENDER JAR (make sure
the blending jar lid cap is
snapped closed) on the motor
base. Press AUTO BLEND.
TIP:
For manual blending, use the LOW,
MEDIUM and HIGH buttons. Press STOP
when drink reaches desired consistency.
Place BLENDER JAR underneath
ICE CHUTE, turn on and press
the AUTO SHAVE button. To
serve a full pitcher, shaved ice
should fill the blender jar up to
the 4-5 cup indicator. Manually
press the PULSE button to add
more shaved ice if desired.
TIP:
To customize your drink, see the
instruction manual.
Remove the BLENDER JAR
from the base, flip open the
lid cap cover and pour the
delicious frozen bliss into
your favorite glass.
BLEND
DELICIOUS FROZEN DRINKS IN 6 EASY STEPS.
P.N. 145352
TIP:
If unit will not start and red arrow lights in center
of Control Panel are flashing, recheck that ICE SHAVER
ASSEMBLY components are in the LOCKED position.
To Previous Page
Loading...
Need help?
General
