Using the Pre-Programmed Settings
1. Press On/O button and press the desired Pre-Programmed
Setting Button:
– “Green/Frozen Smoothie”
– “Food Chop/Salsa”
– “Milkshakes”
2. To change your selection, press “STOP” followed by another
Pre-Programmed or manual Setting button.
3. Once the program is nished the cycle automatically stops. Press
the “STOP” button to cancel the program at any time. The blinking
blue light indicates that the blender is ready.
The Oster
®
Pro 1200 Blender QUICK START GUIDE
Using MANUAL CONTROLS
1. Press On/O Button and Select Manual Control of your choice:
High / Med / Low / Pulse.
2. Press the “STOP” button to cancel the operation at any time.
3. Press the ON/OFF power button to turn blender o.
Using Blend-N-Go
®
Smoothie Cup
www.osterblending.com
©2015 Sunbeam Products, Inc., doing business as Jarden Consumer Solutions. Boca Raton, FL 33431 All rights reserved. PN: 184574 SPR-080415-398P
• After adding ingredients, place blade assembly into cup and turn
clockwise to tighten. Make sure sealing ring is placed between
blade and cup
• Place cup assembly onto Blender base and hold cup in position
to operate. Follow instructions above.
ADD LIQUIDS IN THE JAR FIRST,
THEN ADD REMAINING INGREDIENTS
• Liquid to solid ratio is key!
• Add more liquid if ingredients are not
blending properly.
BONUS TIP: For frozen drinks and smoothies,
add enough liquid to the point where your
solid ingredients begin to oat.
USE PULSE BUTTON FOR CHOPPING
BONUS TIP: Add ingredients in rst that you
wish to process more thoroughly.
FOR BEST ICE CRUSHING
WITHOUT LIQUID
• Up to 6 large ice cubes.
• Use Pulse button until you achieve
desired results.
WITH LIQUID
• Fill jar with ice cubes (no ice limits) and
water until ice oats.
• Blend on high until you achieve desired
results then strain water.
Oster
®
Pro Blending Tips
To Next Page
Need help?
General
