OTC DAIHEN EUROPE Almega AX Series User Manual

No. 1L22440-E-7
A
X
series
INSTRUCTION MANUAL
WELDING INTERFACE
(DIGITAL)
■ Read and follow these instructions and all safety blocks carefully.
■ Have only trained and qualified persons install, operate, or service this unit.
■ Give this manual to the operator.
■ For help, call your distributor.

OTC DAIHEN EUROPE Almega AX Series Specifications

General

Brand	OTC DAIHEN EUROPE
Model	Almega AX Series
Category	Recording Equipment
Language	English

Summary

Chapter 1 Introduction

1.1 Welding Interface (Digital)

General description and purpose of the Welding Interface (Digital).

1.2 Main Specifications

Key technical and operational specifications of the interface.

1.3 Standard Configuration

Describes the standard configuration for the robot welding system.

1.4 Welding Mode Lists

Lists welding modes available for Welbee Inverter series.

Chapter 2 Connections

2.1 Connect Welding Interface (Digital)

Step-by-step guide for connecting the Welding Interface (Digital).

2.2 Electrical Connection Diagram

Provides electrical connection diagrams for various models.

Chapter 3 Configurations

3.1 Workflow

Outlines the workflow for configuring the system.

3.2 Configuration Preparations

Steps for preparing the setup tool and USB media.

3.3 Configuring the Robot Controller

Procedures for configuring the robot controller.

3.4 Creating the Setup Data

Procedure for creating setup data for configuration.

3.5 Writing the Setup Data

Steps for writing setup data to the interface and controller.

3.6 Check the Configuration

Procedure to verify correct configuration.

3.7 Configuring the Welbee Inverter Series Welding Power Source

Front panel operations and internal functions of the power source.

3.8 Welding Conditions of WB-M350L

Details welding conditions for WB-M350L.

3.9 Welding Conditions of WB-M350/500

Details welding conditions for WB-M350/500.

3.10 Welding Conditions of WB-P350

Details welding conditions for WB-P350.

3.11 Welding Conditions of WB-P500L

Details welding conditions for WB-P500L.

Chapter 4 Maintenance

4.1 Displaying the Welding Interface (Digital) Version

Procedure to check the firmware version of the interface.

4.2 List of Welding Interface (Digital) Error Codes

Lists interface error codes and their measures.

4.3 Errors of Welbee Inverter Series Welding Power Source

Lists errors detected by the welding power source.

4.4 Notes on Scope of Warranty and Liability

Information on warranty, disclaimer, and liability.