OTC DAIHEN EUROPE OTC Almega AXC User Manual

No. 1L22440-E-7
A
X
series
INSTRUCTION MANUAL
WELDING INTERFACE
(DIGITAL)
■ Read and follow these instructions and all safety blocks carefully.
■ Have only trained and qualified persons install, operate, or service this unit.
■ Give this manual to the operator.
■ For help, call your distributor.

OTC DAIHEN EUROPE OTC Almega AXC Specifications

General

Brand	OTC DAIHEN EUROPE
Model	OTC Almega AXC
Category	Recording Equipment
Language	English

Summary

Chapter 1 Introduction

Main Specifications

Details hardware, connectable controllers, and welding power sources.

Chapter 2 Connections

Connect Welding Interface (Digital)

Details the physical installation and connection of the interface.

Electrical Connection Diagram

Chapter 3 Configurations

Workflow

Configuring the Robot Controller

Describes procedures for setting up the robot controller.

Creating Setup Data

Writing Setup Data

Procedure for transferring setup data to the interface and controller.

Check Configuration

Configuring Welbee Inverter Welding Power Source

Welding Conditions WB-M350L

Welding Conditions WB-M350/500

Welding Conditions WB-P350

Welding Conditions WB-P500L

Chapter 4 Maintenance

Welding Interface Error Codes

Lists and explains error codes for the Welding Interface (Digital).

Welding Power Source Errors

Lists and explains errors detected by the welding power source.