Form No. 102737
Parts List &
Operating Instructions
for: 1728
014-00942
High Lift Transmission Jack
Max. Capacity: 1,000 lbs. at 90 PSI
Safety Precautions
CAUTION: To prevent personal injury and damage to equipment,
•
Read, understand, and follow all instructions, including the ANSI B30.1 safety code for
jacks.
•
Wear eye protection that meets the requirements of ANSI Z87.1 and OSHA.
•
Inspect the jack before each use; do not use the jack if it’s damaged, altered, or in poor
condition.
•
A load must never exceed the rated lifting capacity of the jack.
•
Use the jack on a hard, level surface.
•
Never move the jack with a load any higher off the ground than necessary. SLOWLY AND
CAREFULLY move the jack around corners, because the load could tip.
•
Do not modify the jack or use adapters unless approved or supplied by OTC.
•
Lower the jack slowly and carefully while watching the position of the load.
•
Use only approved hydraulic fluid (Chevron AW Hydraulic Oil MV or equivalent). The use of alcohol,
hydraulic brake fluid, or transmission oil could damage seals and result in jack failure.
This guide cannot cover every situation, so always do the job with safety first.
The High Lift Transmission Jack is designed
for the installation and removal of automobile
transmissions.
525197
Head Assembly
To Next Page
Need help?
General
