Remote Microphone Connection Procedures for the Oticon Ponto 5 Sound Processor
– EduMic as Transmitter
1. Pair the EduMic to the Ponto (to be done during initial set up only. Pairing holds until EduMic is
manually unpaired from Ponto).
a. Turn OFF the Ponto by opening the battery door.
b. Turn ON the EduMic by pressing the POWER button for 2 seconds until both indicators turn
WHITE then release the button. Wait 10 seconds until the indicator turns GREEN.
c. While holding the Ponto within 20 cm of the EduMic, turn ON the Ponto by closing the battery
door.
d. After the initial start up jingle on the Ponto, wait about 5 seconds. The pairing starts when the
EduMic starts to blink blue. The blinking lasts about 30 seconds, after which the indicator will
turn a steady green. The Ponto is now paired.
To Next Page
Need help?
General
