Need help?Do you have a question about the OTIS GEN2 OI-7032 and is the answer not in the manual?
Step-by-step instructions for connecting a 24V DC power supply to the OI-7032.
Step-by-step instructions for connecting an AC power supply to the OI-7032.
Instructions for connecting power to the OI-7032 touchscreen.
Instructions for connecting the touchscreen data cable (COM port) to the main unit.
Detailed steps for connecting the first wired 4-20mA sensor to the OI-7032.
Detailed steps for connecting the second wired 4-20mA sensor to the OI-7032.
Detailed steps for connecting the third wired 4-20mA sensor to the OI-7032.
Detailed steps for connecting the fourth wired 4-20mA sensor to the OI-7032.
Instructions for wiring the first relay output, including alarm and common connections.
Instructions for wiring the second relay output, including alarm and common connections.
Instructions for wiring the third relay output, including alarm and common connections.
Instructions for wiring the fourth relay output, including alarm and common connections.
Procedure to set channel type to Wired or WireFree for channels 29-32.
Detailed steps for configuring relay settings, including alarm, latching, and values.
Instructions for setting the radio address for WireFree sensor units.
Instructions for setting the scaling value for wired 4-20mA sensors.
Step-by-step guide to access the main configuration menu on the OI-7032 touchscreen.
General| Controller Type | Elevator Controller |
|---|---|
| Series | GEN2 |
| Model | OI-7032 |
| Protection | Overcurrent, Overvoltage, Short Circuit |
| Operating Temperature | 0°C to +50°C |
To Next Page