Otone Soundship - AUX stereo Line-in; Setting the clock, alarm and sleep; Clock setting; Alarm Setting

User Manual
10
● AUX stereo Line-in
• Soundship Micro also offers a 3.5mm AUX line-in jack for use with audio devices not
equipped with Bluetooth or a compatible docking connector.
• Simply plug one end of your 3.5mm cable to your audio device’s headphone jack and the
other end to the speaker.
• Line-in mode will take priority over Bluetooth mode, to return to Bluetooth, just unplug the
3.5mm cable.
● Setting the clock, alarm and sleep:
• Clock setting:
Press CLOCK on remote control to select clock
adjustment mode.
“12H” or “24H” will be displayed on the screen.
Note: This will only work when the speaker is in Clock mode
Once in clock setting mode, and “ 12H ” is flashing on the display press >> or << to
change to “ 24H “ . Then press CLOCK again to confirm the 12H / 24H mode.
Then the hour indication will flash on the screen. Press >> or << to select the time and
press CLOCK to confirm the selection.
After confirming the hour selection, the minute indication will flash on the screen. Press
>> or << to select the minute and press CLOCK to confirm the selection.
Note: During the time setting process if nothing is entered within 5 seconds, the system
will leave the setting mode.
For “ 12H “ mode, AM or PM will be shown on the display.
• Alarm Setting:
Press ALARM on the remote control to select alarm setting mode.
“ON” or “OFF” will be shown on the screen.
Once in alarm setting mode, and “ ON ” or “OFF” is flashing on the display,
press >> or << to change to “ OFF “ or “ON” .
Press ALARM again to select the mode. ON / OFF
Then the hour indication will flash on the screen. Press >> or << to select the time and
press ALARM to confirm the selection.
CLOCK will be displayed
12H