9
Electrical and Warning Labels
Dangerous
Electrical
Voltage
Caution, refer to
accompanying
documents
Caution
Hot Surface
Main Switch
Control
Oven Control
Main Terminal
Blocks
208-240
volt
1 phase
380-400
volt
3 phase
1 Amp
Fuse
208-240V
630 MA
Fuse
380-400V
Fan Control
6
Oven Setup
Remove the 3 screws
securing each light guard.
CAUTION: INFRARED EMITTERS ARE
FRAGILE. HANDLE WITH CARE
11. Insert the threaded ends of the emitter into the L-Brackets in
the light panel. Holding the ceramic at the end of the emitter,
so as not to disconnect it from the glass portion of the emitter,
tighten the nuts at each end against the L-Bracket. Each emit-
ter and two L-Bracket assembly is intended to “float” to allow
for emitter expansion and contraction.
12. Reinstall the light guards.
The light guards should
lightly
touch the emitters
for support after tightening.
To Next Page
Loading...
