Need help?Do you have a question about the OTTO MOTORS 1500 Fast Charger V1.2 and is the answer not in the manual?
General| Category | Robotics |
|---|---|
| Model | 1500 Fast Charger V1.2 |
| Input Voltage | 100-240VAC |
| Input Frequency | 50/60Hz |
| Output Power | 1500W |
| Cooling Method | Forced Air Cooling |
| Operating Temperature | 0°C to 40°C |
| Efficiency | >90% |
| Protection Features | Over voltage, over current, over temperature, short circuit |
| Compliance | CE, RoHS |
Examples of DANGER, WARNING, and CAUTION safety levels.
Lists general hazards like BURN, SHOCK, FIRE, CRUSH, and their associated warnings.
Details specific hazards related to robot operation and movement.
Lists warnings and cautions specific to the charger's electrical and physical hazards.
Outlines potential dangers when using attachments with OTTO Motors products.
Explains common hazard labels and their meanings.
Covers essential safety awareness points for personnel operating near AMRs.
Details environmental and floor conditions necessary for safe AMR operation.
Specifies the maximum weight limits for OTTO AMRs and associated configurations.
Provides safety precautions for handling Lithium battery packs.
Explains how AMRs detect obstacles and the risks of overhangs.
States limitations of liability and user responsibilities for product operation.
Lists the components included with the charger system.
Explains the function and LED indicators of the charge controller.
Describes the display and information provided by the intelligent charger.
Explains the role of the extension cable in connecting components.
Describes how the targeting fixture aids robot alignment.
Details the function of the charge dock and its sensor array for robot interfacing.
Refers to the PosiCharge SVS Installation Manual for instructions.
Details the process and required materials for installing the charge dock.
Guides on selecting an optimal location for charger contacts, avoiding specific environmental factors.
Explains how to check and adjust charge contact height using a gauge.
Instructs on installing the dock target according to specific documentation.
Step-by-step guide for powering on and preparing the charger system.
Procedures for safely powering off the charger system, including LOTO.
Outlines tasks to be performed every two months for optimal charger performance.
Details how to inspect charger components for wear, corrosion, or damage.
Describes the periodic verification of charge contact alignment with robot contacts.
Provides methods for cleaning charge and signal contacts to ensure good conductivity.
To Next Page
