CTC161007 Instant Tent
(076-5446-0)
ASSEMBLY INSTRUCTIONSL R
Step 1: Verify package contents
Tent : 1 each
(A) Main Frame with Connector
(Pre attached to the tent)
Step 2: Assemble poles
1)
(A) 1 each Instant Frame with Connector
(pre-attached to tent)
(B) 1 each Fly Pole
Assemble by placing fibreglass sections
into the stake clip.
Fibreglass poles : 2 each (total)
Rainfly : 1 each
Tent Stakes : 7 each
(B) Fly : 1 each
IMPORTANT NOTES:
Stape 3: Spread tent
1)
Set the tent in desired location.
2)
Locate hub, unwrap tent body with hub at top.
3)
Unfold pole legs as shown below
* Assemble your tent before camping to become
familiar with the assembly.
* Two people are recommended for set-up.
* Select a clean, level area for the campsite, free
of debris and sharp objects, away from a
natural watercourse.
* Use of a ground cloth is recommended to
prolong the life of the tent floor and provide
additional insulation and moisture protection.
* To prevent damage to the zippers, unzip the
doors and windows of the tent prior to
disassembly, allowing air to move freely.
* Seam seal the inside stitched seams of the tent.
This will improve weather resistance. Available
in sporting goods departments. Discolouration
may occur if applied to outside seams.
Step 4: Raise tent
1) Hub is attached at centre of tent roof.
2) Unzip door. Step into open doorway.
3) Grasp hub and lift upward extending the telescoping leg poles until they snap into place.
The tent will rise as the leg poles are extended.
4) Make sure all poles are locked.
CTC 161007 05/15
To Next Page
Loading...
Need help?
General
