Step 6:
Attach fly
Step 8:
Fully assembled
1) Unfold the fly and place over the tent. Make sure that the fly awning is over the front door.
2) Attach the fly to the tent by hooking the plastic s-hook on the fly corners at the stake loop
3) Insert the fly pole (B ) through the sleeve found at the edge of the fly, over the front
door.
4) Flex the pole. Insert ends into the reinforced metal grommets located on each side of the
door in the pole sleeve.
5) Wrap the Vel
cro® f
asteners, sewn on the under side of the fly, around the fib er glass tent
poles.
webbing.
Step 5: Securing the tent
1) Stake down the tent by inserting a stake through the stake loops, located along the
perimeter of the tent.
2) Make certain the tent floor is pulled out evenly and tightly.
3) Hammer the stakes into the ground at a 45° angle using a hammer or mallet.
10) Secure with ties and place in carry bag.
12) Tent must be clean and dry before storage. Store off concrete floor.
Be certain campfires are extinguished.
Dispose of trash appropriately.
Step 9: Disassembly and packing the tent
5) To take down the tent, disassemble in reverse order.
1) Remove accessories (if included).
2) Remove and fold fly.
3) Be sure to leave doors and windows unzipped to avoid zipper damage.
4) Remove stakes with hammers or stake puller. DO NOT pull on tent.
6) Depress the locking button and collapse each telescoped leg.
7) Fold legs inward from the corner joints.
8) Fold all the poles together above the centre hub.
11) Keep loose poles and stakes in bags provided.
9) Lay tent on its side. Roll until excess air is expelled.
Tent appears as shown.
CTC 161007 05/15
Step 7:
Secure guy lines
1) Secure tent using all guy lines and stakes.
Tent must be secured for proper function.
To Next Page
Loading...
Need help?
General
