1/4 and 1/4 Plus Woodhaven
®
Firewood Rack Assembly
Instructions
All Woodhaven Firewood Racks are proudly Made in the US
A!
ASSEMBLY:
To assemble, bolt the horizontal bottom tube (B) on the inside of the
welded end section (A)-see inset. Slide the bolts through from the
A
outside of the rack to give a nice, clean look. The nuts have a nylon
insert to prevent them from working loose. The threaded side of the
nut goes on first and will require (2) 7/16” wrenches to tighten. Do
not over tighten.
COVER:
Woodhaven was the first to design covers to cover firewood the way it
needs to be! It keeps the top dry and ready to burn, and allows for air
A
to flow through the firewood to reduce mold and mildew and promote
B
curing. Our standard cover fits around the 4 uprights of the rack
and moves down as the wood stack is used. Sewn-in wind straps may
be used for windy conditions.
Full Covers are available at www.firewoodracks.com
B
IMPORTANT PLACEMENT:
To prevent the possibility of this product tipping over, it MUST be placed on a hard, level surface such as concrete or
heavy concrete stepping stones for each foot. NEVER PLACE T HI S RACK ON DI RT OR ANY OTHER UNSTABLE
SURFACE.
FIREWOOD:
To find a firewood dealer in your area or to find more information about proper burning techniques and firewood information
p
lease visit
www.firewoodcenter.com.
FEEDBACK:
We value your feedback. Visit us at
www.firewoodracks.com/contact.html
to leave any comments, suggestions or testimonials.
To Next Page
Need help?
General