MAINTENANCE
Routine maintenance is critical to ensure proper
machine operation and cleaning performance. Perform
all maintenance procedures as follows:
Always disconnect and remove batteries before
performing any maintenance. See front page
for warnings.
Daily Maintenance
• Inspect the battery cord, battery connectors and
charger connectors for any damage.
• Remove the debris canister, remove the primary filter
and filter cup, and empty the contents into an approved
trash receptacle. See photos 18, 19 and 20.
Knock/shake the debris from the filter and cup into an
approved trash receptacle (photo 21). Always reinstall
the filter
and the
cup.
Weekly Maintenance
• Verify that all daily maintenance has been done.
• Inspect filters for wear, damage, or clogging. Clean
or replace as required. The primary pleated filter can
be rinsed out with water.
Every 6 months
• Charge all spare batteries within 6 months of date of
manufacture.
• Check carbon brushes for wear. When carbon
brushes are worn to 1/2" in length return the machine
to an authorized NSS Service center.
• Inspect filter cup for clogging, or damage. Clean or
replace as needed. Can be cleaned with warm water
• Clean (with warm water running from inside out) or
replace the primary pleated filter as needed. Allow to
dry before use if cleaned with water.
• Inspect secondary foam filter for wear, clogging, or
damage. Clean or replace as needed.
• Inspect the HEPA filter (if equipped) for wear,
clogging, or damage. Clean or replace as needed.
Annually
• Replace all filters.
Other
• Replace batteries after approximately 500 cycles.
Batteries need replaced when runtime is
significantly diminished.
Optional Equipment
6793111 HEPA filter
Brute Mounted Outlaw PB parts (photo 22)
6990781 Hanger Brackets 2
6990791 Accessory Skirt 1
6990801 10 ft Hose 1
Photo 21
Photo 18
Photo 19
Photo 20 Photo 22
To Next Page
Loading...