Outlaw PB - Troubleshooting Guide; Machine Not Running Issues; Poor or No Suction Issues; Short Battery Life Issues

TROUBLESHOOTING
Symptom Cause
Solution
Machine Does Not Run. Batteries are fully discharged. Re-charge the batteries.
Batteries plugged in improperly.
Trigger connector not plugged into
hose properly.
Re-plug the batteries.
Ensure proper insertion.
Damaged cable or connector Repair
Machine Has Poor Or No Suction. Obstruction in Hose, Tool or Wand. Remove Obstruction.
Pre-filter or primary filter plugged. Clean or replace filters.
Full debris canister. Empty canister.
Inlet plug not installed. Install plug in unused inlet.
Vac Motor Worn out. Replace.
Carbon Brushes Worn. Replace.
Canister not latched properly. Secure canister with clamps.
Foam exhaust filter dirty. Replace.
Filter gasket Missing or Damaged... Replace.
Batteries only last for a short time
Batteries not fully charged
Batteries old
Charge
Replace
Repair service for this machine must be performed by an NSS authorized service center. Repairs performed by an
unauthorized company will void the machine warranty. If you require assistance finding an authorized service center,
contact NSS Enterprises.
NSS
®
Enterprises, Inc.
3115 Frenchmens Road, Toledo, Ohio 43607
PHONE (419) 531-2121 FAX (419) 531-3761
NSS ® Enterprises, Inc. European Distribution Centre
Unit II, Pinfold Trading Estate * 55 Nottingham Road
STAPLEFORD, NOTTINGHAM NG9 8AD ENGLAND U.K.
PHONE: (44) 0115 939 1568 * FAX: (44) 0115 949 0615
Outlaw PB Dr
y
Vacuum Operation Manual Rev H 05-12 6991051