EasyManuals Logo

oventrop Aktor M Technical Information

oventrop Aktor M
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
2017 Oventrop 1
“Aktor M”
Electromotive actuators
Tender specication:
Oventrop electromotive actuators for steady control. The actuator
can be used for two point, three point or proportional control
(0-10 V), with squeeze connection and position feedback signal
0-10 V.
Models: Item no.:
24 V, steady control with 0-10 V 1158010
or switching as two or three point control.
Type of characteristic line
(linear, equal percentage) adjustable.
With enclosed adapter for Oventrop valves.
Same actuator as item no. 1158010 1158011
but without enclosed adapter
Technical data:
Operating current: 24 V ~/=
Power consumption: 4.9 W during operation
8.7Winnalliftposition
Drive: 0 - 10 V
Max. piston stroke: 10 mm
Operating power: 500 N
Floating time: 7.5 / 15 s / mm
Protection: IP 54 according to EN 60529
Max.uidtemperature: 120°C
Ambienttemperature: -10°Cupto+55°C
Storagetemperature: -10°Cupto+55°C
Connectingcable: 5x0.5mm²
Installation:
The connecting cable must not come into contact with the hot pipe
as excessive heat will accelerate the ageing of the cable insulation.
Electrical connection must be carried out in accordance with the
requirements of the local Electricity Board.
The Oventrop electromotive actuators can be installed in any
position, except for vertical downward position.
Depending on the wiring (see connection diagrams), the actuators
item no. 1158010/11 can be used as two point, three point or
0-10 V actuator.
Application:
The actuators can be combined with the following Oventrop
valves:
Item no. 1158010:
“CoconQTR/QFC”DN40andDN50
Item no. 1158011:
Two-way valves item no. 11308.. and 16708 DN 15-DN 50
Function:
Synchronous motor with activation and switch off technology
Electronic recognition of the limit of travel via timer
Maintenance-free gear with magnetic coupling
Gear release for manual positioning of the valve. To do so,
activate the lateral sliding switch and set the actuator to the
required position with the help of the enclosed key.
P
M
24 V~/=
MM
0201
A/D
05
y=0...10V
y0=0...10V
03
BU
BK
BN
RD
GY
MM
02
01
0503
24 V~/=
open/stop/close
Variante 1 (3pt)
24 V~/=
open / close
Variante 2 (2pt)
50MM03
BU
RD
GY
BU
BK
BN
RD
GY
02
01
BK
BN
Variante 3 (0-10 V)
Connectiondiagramsitemno.1158010/11
Dimensions with mounted adapter
Technical information
157
35
122
126.5
63
43.5
Actuator
Adapter
Variant 1 (3pt)
Variant 2 (2pt)
Variant 3 (0-10 V)

Other manuals for oventrop Aktor M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the oventrop Aktor M and is the answer not in the manual?

oventrop Aktor M Specifications

General IconGeneral
Brandoventrop
ModelAktor M
CategoryController
LanguageEnglish

Related product manuals