Overland Storage SnapServer XSR 40 Replacement Instructions

10400561-001 ©2014 Overland Storage, Inc. Page 1 of 5
*10400561-001*
SnapServer
®
XSR 40
Chassis Replacement Instructions
This document describes how to replace a chassis in a
SnapServer XSR 40 from Overland Storage.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
WARNUNG: Um das Risiko eines elektrischen Schlags oder
Schäden am Gerät zu vermeiden, ziehen Sie stets den
Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT: Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
Prepare the Unit
Power Off and Disconnect
If the unit is still running, power it down cleanly:
1. Use the Web Management Interface to shut down the
server (Maintenance > Reboot and Shutdown >
Shutdown).
2. When all the LEDs are off, disconnect the power cords.
3. Disconnect the remaining cables from the unit.
Remove the Front Bezel
1. Carefully take hold of the front bezel by the right and
left flanges and pull straight out from the appliance until
the retaining clips release.
2. Set the bezel aside on a secure surface.
Pull Pull

Overland Storage SnapServer XSR 40 Specifications

General

Brand	Overland Storage
Model	SnapServer XSR 40
Category	Server
Language	English