Why am I not receiving motion detection notifications from my Overmax Camspot 3.7 Pro?
To ensure you receive notifications when your Overmax Digital Camera detects movement, verify that push notifications are enabled both in your phone's settings and within the camera's application settings.
What to do if Overmax Camspot 3.7 Pro won't connect to WiFi after entering the correct password?
If your Overmax Digital Camera fails to connect to the 2.4 GHz Wi-Fi network after entering the correct password, ensure that both your phone and the camera are connected to the same network. Also, verify that DHCP protocol is enabled. Reset the device by holding the reset button for 8 seconds. Make sure the Wi-Fi signal is strong.
How to reset Overmax Digital Camera to factory settings?
To reset your Overmax Digital Camera to its factory settings, either remove the camera from the device list in the application or press and hold the reset button for 5 seconds until you hear a beep.
How do I change the router my Overmax Digital Camera is connected to?
To change the router your Overmax Digital Camera is connected to, remove the camera from the device list in the application or press and hold the reset button for 8 seconds until you hear a beep. Then, set up the device again.
What to do if Overmax Digital Camera doesn't recognize the microSD card?
If your Overmax Digital Camera does not recognize the microSD memory card, check the camera settings to ensure that saving image and sound material to the microSD card is enabled. The device supports memory cards with a capacity of up to 128 GB. Ensure that the memory card is not damaged and supports the FAT32 format.
General| Brand | Overmax |
|---|---|
| Model | Camspot 3.7 Pro |
| Category | Digital Camera |
| Language | English |
To Next Page
