Remove the 2 Phillips screws from
the bottom of the enclosure.
Remove the top cover.
Insert your 2.5” SATA Hard Drive
onto the bridge card.
Replace the top cover.
Replace the 2 Phillips screws from
the bottom of the enclosure.
Plug the included USB 3.0 SuperSpeed cable into the OWC Express enclo-
sure and your computer. If the drive you installed was previously used and
is already formatted, the drive will mount on your computer’s desktop
and is ready to use.
If you have installed a new hard drive, you will need to format the drive to
use it. Instructions for most popular operating systems are available here:
http://eshop.macsales.com/tech_center/harddrives.cfm
Thank you from Other World Computing!
To Previous Page
Loading...
