10 GB
Inserting / changing
the battery
If the battery symbol appears in the display
7
,
the inserted battery is almost drained and must be
replaced. Empty batteries can falsify the measured
result.
To insert the battery proceed as follows:
Open the battery compartment cover on the
back of the device. You can remove the used
battery more easily with the aid of the material
strip, which is inside the battery compartment
6
. Just pull on the material strip.
Remove the used battery.
Plug the contacts of the 9 V-blockbattery on
the contacts of the profiled plug. Make sure
you fit the batteries the right way round. This
is specified by the profiled shape of the con-
tacts. Also ensure without fail that the material
strip is underneath the battery.
Insert the battery in the battery compartment
and close the cover again, so that it audibly
latches into place.
Start-up
Before you take a
measurement
Ensure that both measuring pins
2
touch the
surface of the material at the same time.
Increase the pressure on the measuring pins
for rough surfaces if necessary.
For delicate surfaces complete the measure-
ment on a section that is not in the visible
area.
To Next Page
Loading...
Need help?
General
