Protect sensitive parts
Make sure the abrasive part of the hook and loop fastener is not touching
the skin.
Sock should not extend over the toes.
Check Sock Size
Sock too small
If either strap fails to naturally reach the hook and loop fastener, try a larger
Sock size. Do not stretch the straps and cinch the Sock too tight or it might
be uncomfortable for your baby.
Sock too big
If either strap goes past the hook and loop fastener, try a smaller Sock size.
The Sock and hook and loop fastener straps should be snug against the foot.
TOO BIG
TOO SMALL
Strap too long
Red/pinched skin
Strap too short
Loose around foot
Check Straps
Verify the straps are adjusted correctly.
Do NOT over tighten.
Straps should lay flat against the skin but not press into the skin.
Do not stretch the straps when fastening - this leads to overtightening.
CA
U
TION.
Do NOT apply the Sock and Sensor too tightly. Too much
pressure for long periods can cause a pressure in
j
ury.
CA
U
TION.
A
lways ensure that the Sock with Sensor is placed correctly
on the baby
’
s foot.
P
oor Sensor placement may cause skin
irritation.
CA
U
TION.
E
nsure the abrasive patches of hook and loop fastener are not
contacting the baby
’
s skin, as this may lead to skin abrasion.
CA
U
TION.
Signs of skin irritation or excessive alarms can be an indicator
of incorrect Sock size.
CA
U
TION.
If the Sensor windows are pulling away from the foot, the
Sock may be too loose. Try tightening the Sock or use a
smaller Sock size.
A
ir gaps between the baby
’
s foot and the
Sensor can cause intermittent readings or fre
q
uent false
alarms.
28
To Next Page
Loading...