Step 4: Position the Sock
Place the Sock on the corresponding foot (le/right) with the notch on the
outside of the foot behind the pinky toe. The Sock should NOT touch the
toes. The word “TOP” should be placed on the top of the foot near the toes
and not at the ankle.
(2)
Secure the hook and loop fastener from the toe strap (1) around the foot
above the toes and then wrap the ankle strap around the back of the ankle
and secure it to the top of the foot (2). Do NOT stretch when fastening. Let
the hook and loop fastener pieces connect naturally without stretching. The
Sock should lay flat against the skin without gaps between the Sock and the
foot.
CAUTION.
Do not stretch the straps when fastening. Stretching straps
will lead to over tightening and increased risk for skin
irritation.
CAUTION.
Do not fasten the Sensor to the baby’s foot using anything
other than the Sock. Injury to the baby's foot may result.
CAUTION.
Do NOT use lotions, creams or powder on the feet before
applying the Sock and Sensor. Application site must be clean
and dry to avoid skin irritation.
CAUTION.
Do NOT apply the Sock and Sensor to wet skin. Excess
moisture may increase the risk of skin irritation.
CAUTION.
Verify the Sock and Sensor are dry and free of dirt, hair or
other foreign substances before placing on the baby.
Step 5: Verify Sock Fit & Placement
Match Sock to Foot
Make sure to use the le Sock for the le foot and the right Sock for the right
foot. Each Sock is marked with “
R
” or “L”.
(
1
)
notch
27
To Next Page
Loading...