CAUTION.
Regularly verify Sock fit. The baby’s actual foot size may dier
from the guidelines above and babies grow quickly. Stop
using the device when your baby reaches 30 lbs or outgrows
the largest Sock.
CAUTION.
Even if your baby meets the age and weight requirements, if
all Sock sizes are either too small or too large, discontinue
use of BabySat.
CAUTION.
Alternate Sock between feet every 8 hours of use or aer
recharging the Sensor. Check the application site oen for
any signs of irritated skin.
CAUTION.
BabySat performance may be aected by foot deformities.
Because foot deformities vary widely in nature and severity,
we recommend that you consult your pediatrician before use
on babies with foot deformities.
Replacement Socks can be purchased from Owlet
(see Section 14).
In App: Guide > BabySat Basics>Sock Placement: How to Get Reading
Sock fit refers to the snugness of the Sock on the foot. Sock placement refers
to the orientation and alignment of the Sock to the foot. Proper Sock size, fit
and placement is essential for BabySat performance.
Step 3: Insert the Sensor (If not already attached)
Attach the Sensor to the Sock by lining up the notch on the Sensor with the
notch on the Sock. Stretch the hole in the Sock over the Sensor.
Always inspect the Sock and Sensor for damage or excessive wear and verify
that the Sock and Sensor, including the Sensor windows, are clean before
use.
! NOTE.
Ensure the Sensor is completely inserted into the Sock before use.
D
iscontinue Sock use if you notice any damage to the Sock.
26
To Next Page
Loading...