Owlet BabySat - Page 37

Clearing Alarms
All alarms will continue until the underlying alarm condition has stopped or
the Base Station is turned o. Depending on the alarm priority, a user
acknowledgment of the alarm may also be required. The requirements for
clearing an alarm are:
For Alarms to Clear:
HIGH PRIORITY
MEDIUM PRIORITY
LOW PRIORITY
UNDERLYING ALARM
CONDITION MUST BE
RESOLVED
AND
ALARM MUST BE
ACKNOWLEDGED
WITH A PAUSE
COMMAND
ACKNOWLEDGED
BY A PAUSE
COMMAND OR 30
SECONDS HAVE
ELAPSED
NO
ACKNOWLEDGM
ENT REQUIRED
Other Audible Information Indicators
The Base Station produces other audible indicators to provide information
during user interaction. When monitoring is turned on, a quiet series of
tones rising in pitch are played. A similar tone, decreasing in pitch is played
when monitoring is turned o. The Base Station also produces several chirps
when the Base Station Button is long pressed.
8.6 Charging the Sensor
We recommend that you charge the Sensor whenever it is not in use. Charge
the Sensor by placing the Sensor onto the Base Station. The Base Station
pulses white while charging the Sensor and switches to a solid white when
the Sensor is fully charged.  BabySat uses convenient drop - and - go charging
for an 8- hour charge in j ust 2 0 minutes, and full 16- hour charge in only 9 0
minutes. 
WAR N I N G !
Do not attempt to charge the Sensor while the Sensor is on
the Baby ’ s foot.
! N OTE.
The Sensor can be charged while inside the Sock.
! N OTE.
The App will only indicate if the SENSOR IS CHARGING or F ully
Charged while the Sensor is on the Base Station.
8. 7 When to discontinue use of B ab y Sat
Stop using BabySat if 
 The baby has skin irritation on both feet 
 The baby weighs more than 30 lbs 
 The Sock no longer fits properly.
! N OTE.
Contact your healthcare provider if your baby has outgrown  but the
prescription implies that pulse o x imetry monitoring should continue.
3 6