43
6
1.How to pair the thermostat with Remote Zone Sensors?
1. Click the '+' button at the top right of the interface in 'Menu' -> 'Sensors'
on the thermostat and tap 'Next'.
2. Remove the rear cover of the sensor.
3. Press and hold the button on the back of the sensor for 3 seconds until the
indicator on the front of the sensor ashes red.
4. Wait for sensors to pair automatically. When the pairing is successful, the
sensor ashes green 3 times.
Now you can set the participation period of the sensor. During this period,
the thermostat will take the average temperature of all the sensors that
recently detected motion as the indoor temperature on the main screen.
FAQ
513 29.8/Occupied
My Sensor 24.9/Occupied
Please press and hold the
button on the back of the
sensor for 3 seconds, the
indicator will flash red,
then tap ‘Next’.
Tip: During sleep time, the sensor enabled during this period doesn't
care about occupancy; it will always participate in the calculation of the
average temperature. When you change the setting of sensor, the indoor
temperature on the main screen will update in 2 minutes.
To Next Page
Loading...