To Next PageTo Next Page
Need help?Do you have a question about the Oxbox J951X U Series and is the answer not in the manual?
General| Fuel Type | Natural Gas |
|---|---|
| AFUE | 95% |
| Ignition System | Hot Surface Ignition |
| Heating Capacity | 40, 000 - 120, 000 BTU/h |
| Warranty | 10 Years Parts Limited Warranty |
Critical safety information and warnings applicable to installation, service, and operation.
Guidelines and precautions for operating the furnace during building construction phases.
Overview of codes and general requirements governing furnace installation, including safety.
Specifies minimum safe distances from the furnace to surrounding combustible materials.
Specific requirements for installing the furnace safely within a garage environment.
Essential guidelines for providing adequate combustion air and proper venting of flue gases.
Instructions for direct vent (2-pipe) systems, drawing air from outdoors and venting outside.
Requirements for venting in confined spaces, defining volume and air supply needs.
Special material and installation procedures for Category IV appliances requiring sealed systems.
Fundamental requirements for furnace installation, including leveling and protection from water.
Specific considerations for installing furnaces in the upflow configuration.
Guidelines for installing furnaces in horizontal orientations, including attic or basement placement.
Procedures and warnings specific to installing furnaces in the downflow configuration.
Flexibility in rotating the inducer assembly for various venting configurations and requirements.
Installation guidelines and requirements for gas supply piping, including leak testing.
Adjustments for natural gas furnaces installed at altitudes above 2,000 feet.
Instructions and warnings for converting the furnace from natural gas to LP/Propane fuel.
Proper installation of line voltage, low voltage wiring, and grounding for furnace safety and operation.
Essential checks to perform before initiating furnace start-up to ensure safety and correct installation.
Step-by-step instructions for safely starting the furnace after installation and checks.
Procedure to measure and set the furnace's gas input rate according to rating plate specifications.
Guidelines for air filter, burner, and vent system maintenance for optimal performance and safety.
Diagnosing and resolving common furnace operational issues using LED indicators and component checks.
Comprehensive checklist for electrical, gas, and venting systems before final sign-off.
