EasyManua.ls Logo

Oxhark Flame WM36DR - Page 2

Oxhark Flame WM36DR
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IMPORTANT:
IMPORTANT:
IMPORTANT:
IMPORTANT: It
It
It
It is
is
is
is important
important
important
important to
to
to
to read
read
read
read these
these
these
these instructions
instructions
instructions
instructions carefully
carefully
carefully
carefully before
before
before
before using
using
using
using the
the
the
the appliance
appliance
appliance
appliance for
for
for
for
the
the
the
the first
first
first
first time.
time.
time.
time. Keep
Keep
Keep
Keep the
the
the
the instructions
instruc
tions
instructions
instructions safe
safe
safe
safe so
so
so
so that
that
that
that you
you
you
you can
can
can
can refer
refer
refer
refer t
t
t
to
o
o
o them
them
them
them later
later
later
later if
if
if
if necessary.
necessary.
necessary.
necessary.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
1. Read all instructions before installing or using this heater
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible
materials, such as furniture, pillows, bedding, papers, clothes, etc. and curtains at least 0.9 m from the front
of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the
heater is left operating and unattended.
4. Do not operate any heater after it malfunctions. Disconnect power at service panel and have heater
inspected by a reputable electrician before reusing.
5. Do not use outdoors.
6. To disconnect heater, turn controls to off, and turn off power to heater circuit at main disconnect panel (or
operate internal disconnect switch if provided).
7. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
8. To prevent a possible fire, do not block air intakes or exhaust in any manner.
9. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or
flammable vapors or liquids are used or stored.
10. Use this heater only as described in this manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons.
11. This heater may include an audible or visual alarm to warn that parts of the heater are getting excessively
hot. If the alarm sounds (or illuminates), immediately turn the heater off and inspect for any objects on or
adjacent to the heater that may have blocked the airflow or otherwise caused high temperatures to have
occurred. DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING (OR ILLUMINATING).
12. “SAVE THESE INSTRUCTIONS”
This heater is for use on 120 volts. The cord has a plug as shown below Figure. An adapter as shown at C is
available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.
The adapter should not be used if a three-slot grounded receptacle is available.