5 6
1
Test Booster attachment to ensure it is securely attached
to chair.
Release safety harness by unbuckling two waist straps
from crotch strap. Place child on Booster and place crotch
strap between child’s legs. Buckle two waist straps into
crotch strap buckle. You will hear a “click” when
buckles lock.
Note: Pull on harness to check that both belts are locked
into the buckle.
2
Adjust waist straps until child is snug in Booster.
To loosen, slide the strap adjusters towards the center.
To tighten, slide the strap adjusters away from the
center. To remove child, release buckles by unbuckling
two waist straps from crotch strap.
Test strap security after adjusting straps. Do not leave
child unattended.
Strapping Child into Booster
• Always secure child with the restraint system to fit child snugly. Do not remove chair straps. All straps can be removed for Booster
storage.
WARNING
!
Safety harness
Chair back & bottom
attachment straps
Booster comes with chair back and bottom attachment
straps and safety harness attached. Unbuckle all buckles
before beginning attachment.
Position Booster securely on chair as far back on seat as
possible. Wrap chair bottom attachment strap around base
of chair and buckle under seat. You will hear a “click” when
buckle locks.
Wrap chair back attachment straps around chair back and
buckle behind seat. You will hear a “click” when buckle locks.
Ensure both sets of straps are tight by adjusting the straps
until there is no slack. Pull loose end of strap to tighten.
ASSEMBLY
Attaching Booster to ChairIncluded
Only use on chairs that have a back. Never use on table, countertop, stool or swivel chair.
WARNING
!
To Next Page
Loading...
General