OYAMA OY380-2 - User Manual

English
GREAT BRITAIN • customer service tel: 0845 300 9799 e-mail: customerservice@clasohlson.co.uk internet: www.clasohlson.com/uk
2
3
4
5
6
7
1
Ver. 20140123
Solar Powerbank
Art.no 38-6140 Model OY380-2
Please read theentire instruction manual before using theproduct and
then save it for future reference. We reserve theright for any errors in
text or images and any necessary changes made to technical data.
Ifyou have any questions regarding technical problems please
contact our Customer Services.
Safety
• Never attempt to open or dismantle thesolar charger.
• Never subject thesolar charger to knocks orblows.
• Do not let children play with thesolar charger.
• The solar charger is splashproof but should never be immersed in
water or any other liquid.
• Do not leave thesolar charger in thesun in aconfined space
such as acar, doing so could lead to themaximum operating
temperature (45 ºC) being exceeded.
Buttons and functions
Operating instructions
Charging thesolar charger via thesolarpanel
• Place thesolar charger in thesun.
• The green LED indicator shines strongly or weakly depending on
how efficiently thesolar charger is being charged.
• When thesolar charger is fully charged theLED indicator goesoff.
• In optimum conditions it takes 20 hours to fully charge thesolar charger.
Charging thesolar charger from anexternal power source
• Connect thesolar charger’s built-in USB cable to acomputer,
mains USB charger or 12V car USB charger.
• The green LED indicator comes on to indicate that thesolar charger
is being charged.
• When thesolar charger is fully charged theLED indicator goesoff.
• An external power source takes 5–7 hours to fully charge
thesolar charger.
Charging anexternal device via thesolar charger
Note: Theincluded USB/Micro-USB cable is specially designed for
charging Android phones and is not suitable for data transference.
• Check that thesolar charger is adequately charged by pressing
[
]. Thebattery charge status is indicated by theLEDs:
- All lit - fully charged
- Two lit - half capacity
- One lit - solar charger needs charging
• The solar charger, can, if at least at half capacity, fully charge
astandard mobile phone.
• The solar charger needs to be fully charged if you wish to utilize
both USB ports and charge two devices simultaneously.
Note: Whenthesolar charger is in use and its battery charge level is
very low, thesolar charger will automatically shut off in order to protect
its battery from adeep discharge. Whenthesolar charger begins to
recharge, it takes 3 minutes before it can output any charging current.
Apple products and other products with their own charger cables
• Use thedevice’s charger cable by connecting it between thedevice
and thesolar charger.
• Press [ ] to start charging.
• Disconnect thecharger cable form thesolar charger to finish charging.
• It takes about 90 minutes to fully charge astandard phone.
• The solar charger shuts off automatically as soon thedevice being
charged is disconnected.
Android phones
• Use theincluded USB/Micro-USB cable by connecting it between
theAndroid phone and thesolar charger.
• Press [ ] to start charging.
• Disconnect thecharger cable form thesolar charger to finish charging.
• It takes about 90 minutes to fully charge astandard phone.
• The solar charger shuts off automatically as soon thedevice being
charged is disconnected.
LED torchlight
Hold in [ ] for about 2 seconds to switch thetorch on andoff.
Care and maintenance
• Clean theproduct using alightly moistened cloth. Onlyuse mild
cleaning agents, never solvents or corrosive chemicals.
• Keep thesurface of thesolar panel clean for optimum performance.
Troubleshooting guide
The external
device is not
being charged.
• Is thesolar charger’s built-in battery charged?
• Have you pressed [ ] to start thecharging
process?
• Is thecable you are using in good condition
and correctly connected to both theexternal
device and thesolar charger?
The solar
charger’s built-
in battery is not
being charged.
The prevailing light conditions are not adequate to
charge thebattery. Waituntil thelight conditions
are better or connect thesolar charger to another
USB charger using thebuilt-in charger cable on
theback of thesolar charger.
Disposal
This product should be disposed of in accordance with local regulations.
Ifyou are unsure how to proceed, contact your local authority.
Specifications
Battery 4000 mAh lithium-polymer
Solar panel 5 V 250 mA max (optimum conditions)
Input voltage 5 V DC/800mA
Output voltage 5 V, 2×1A
Operating temperature 0–45 °C
Size 165×85×15mm
Weight 162g
Front
1. Solar panel for charging thesolar charger’s built-in battery
2. USB port for charging electronic devices
3. LED indicator which shows thesolar charger’s battery charge status
4. LED indicator which shows thesolar charger’s efficiency
5. [
] On/off
6. USB port for charging electronic devices
Back
7. USB cable for charging thesolar charger’s built-in battery

OYAMA OY380-2 Specifications

General

Brand	OYAMA
Model	OY380-2
Category	Accessories
Language	English