QUICK SETTING TABLE
C1 plate should be fixed to hole no. “3”
OVERFLOW PLATES
SEEDING DISC
• Ø4.5mm or Ø5mm hole diameter
• Preferably “20” or “26” holes
Note: For bigger size seeds, Use Ø5mm holed disc
and for medium size seeds, use Ø4.5mm holed disc.
If it is observed that Ø4.5mm holed disc is not holding
the seeds then Ø5mm holed disc must be used.
We recommend, to set your machine to the following values for Corn seeds.
SELECTORS (SINGULATORS)
A SELECTOR SETTING
Outer selector handle should be fixed to hole
no. “11” or “12”
B SELECTOR SETTING
Inner selector handle should be fixed
to hole no. “6”
CORN SEED (Medium Size / Big Size)
42
To Next Page
Loading...