PUMPKIN SEED
SELECTORS (SINGULATORS)
A SELECTOR SETTING
Outer selector handle should be fixed to hole
no. “12” or “13”
B SELECTOR SETTING
Inner selector handle should be
fixed to hole no. “8” or “9”
B SELECTOR - ATTENTION: REMOVE
He the standard selector plate located on the Internal
selector will be removed. Instead of this special selector
plate for this seed will be attached.
With this special selector plate, a seeding disc with THIN
nail mixers must be used. Never use this plate with
other seeding discs. It damages the machine.
OVERFLOW PLATES
• Only C3 plate should be attached.
• C1 plate will be removed.
SEEDING DISC
• Ø3.5mm or Ø4mm hole diameter
• Special 16 THIN round mixer plate
• Preferably “8” holes
QUICK SETTING TABLE
We recommend, to set your machine to the following values for Pumpkin seeds.
54
To Next Page
Loading...