DRILL DRIVER OPERATION (cont.)
13
Wood Drilling
Mark the place where you want to drill with a punch or a nail.
To avoid splintering on breakthrough, either clamp a piece of scrap wood to the
back of your workpiece or continue the hole from the back of the wood when
the drill bit first breaks through.
LED Lights
The drill has 1 LED Light (3) built into the unit. The LED
light is located above the variable speed switch (Fig. 9).
The LED light (3) turns on automatically when you
depress the variable speed trigger (5).
The LED light illuminates dark areas in tight
corners to assist with drilling and screw driving.
This helps achieve a more accurate result in your
workpiece.
1.
2.
1.
2.
Fig. 9
To Next Page
Loading...
